Calibration of gauge blocks by mechanical comparison: Northern European comparison final report

Antti Lassila

Calibration of gauge blocks by mechanical comparison: Northern European comparison final report

Research output: Book/Report › Report

Abstract

This comparison was undertaken to verify the competence of participating laboratories in mechanical gauge block calibrations up to 300 mm length. The initiative was taken by the Estonian national measurement institute Metrosert. The protocol used was adapted from EUROMET comparison 601 with small changes. The participants agreed that this would be carried out as a co-operational EUROMET project rather than as a supplementary comparison. Thus the general EUROMET guidelines for comparisons were essentially followed. The EUROMET project reference number is 639.

Original language	English
Place of Publication	Helsinki
Publisher	Centre of Metrology and Accreditation (MIKES)
ISBN (Print)	952-5209-70-9
Publication status	Published - 2002
MoE publication type	D4 Published development or research report or study

Publication series

Series	MIKES Publication
Number	J4/2002
ISSN	1235-5704

Access to Document

http://www.vtt.fi/inf/pdf/MIKES/2002-J4.pdf

Cite this

@book{a30da4f521ad4613a44469a69435ee4d,

title = "Calibration of gauge blocks by mechanical comparison: Northern European comparison final report",

abstract = "This comparison was undertaken to verify the competence of participating laboratories in mechanical gauge block calibrations up to 300 mm length. The initiative was taken by the Estonian national measurement institute Metrosert. The protocol used was adapted from EUROMET comparison 601 with small changes. The participants agreed that this would be carried out as a co-operational EUROMET project rather than as a supplementary comparison. Thus the general EUROMET guidelines for comparisons were essentially followed. The EUROMET project reference number is 639.",

author = "Antti Lassila",

note = "HUO: Euromet Project 639 ",

year = "2002",

language = "English",

isbn = "952-5209-70-9",

series = "MIKES Publication",

publisher = "Centre of Metrology and Accreditation (MIKES)",

number = "J4/2002",

address = "Finland",

}

TY - BOOK

T1 - Calibration of gauge blocks by mechanical comparison

T2 - Northern European comparison final report

AU - Lassila, Antti

N1 - HUO: Euromet Project 639

PY - 2002

Y1 - 2002

N2 - This comparison was undertaken to verify the competence of participating laboratories in mechanical gauge block calibrations up to 300 mm length. The initiative was taken by the Estonian national measurement institute Metrosert. The protocol used was adapted from EUROMET comparison 601 with small changes. The participants agreed that this would be carried out as a co-operational EUROMET project rather than as a supplementary comparison. Thus the general EUROMET guidelines for comparisons were essentially followed. The EUROMET project reference number is 639.

AB - This comparison was undertaken to verify the competence of participating laboratories in mechanical gauge block calibrations up to 300 mm length. The initiative was taken by the Estonian national measurement institute Metrosert. The protocol used was adapted from EUROMET comparison 601 with small changes. The participants agreed that this would be carried out as a co-operational EUROMET project rather than as a supplementary comparison. Thus the general EUROMET guidelines for comparisons were essentially followed. The EUROMET project reference number is 639.

M3 - Report

SN - 952-5209-70-9

T3 - MIKES Publication

BT - Calibration of gauge blocks by mechanical comparison

PB - Centre of Metrology and Accreditation (MIKES)

CY - Helsinki

ER -